Right this moment’s House owner Radio Present Podcast| June 10, 2023

This image is a split image. tHe photo on the left is of a screw being crewed into a wall with a screwdriver. The right photo is a garbage disposal.
Discover ways to forestall drywall nails from coming out and what ought to and shouldn’t be put down a rubbish disposal. (3 Echoes Content Studio)

Hour 1

Hear to listen to how you can forestall nails from pooping out, elevate an out of doors dryer vent’s peak, and extra!


Tips on how to Cease Drywall Nails from Popping Out

This image is of someone screwing a screw into a wall with a screwdriver.
Use a drywall screw as an alternative of a nail to cease nails from backing out. ( 3 Echoes Content Studio)

A home-owner’s home was in-built 1954 and he or she is bored with watching nails again out of the drywall.

She asks, “How do I repair this? Can I pound the nails again in?”

First, pounding the nails again in is only a non permanent repair — they’ll ultimately come out once more. However the greater query is that this: why does it occur?

In a house, there’s quite a lot of motion — doorways slamming, individuals strolling, and many others. All these actions trigger vibrations. And, over time, these vibrations will trigger a drywall nail to again out.

To repair this downside, you’ll have to take away the nails and substitute them with screws as a result of drywall screws are the higher possibility.

You don’t wish to simply take away the nail and substitute it with a screw earlier than checking if the nail is within the middle of the stud or near the middle. The stud may be the explanation it’s coming out.

So, we suggest taking a hammer and a ending nail and tapping by the drywall till you discover the middle of the stud.

As soon as you discover the middle and pull out the nail, then drive one or two drywall screws an inch or two above the previous nail gap. This can maintain it tight.

After changing the nail with a drywall screw, put joint compound over the screw heads and within the previous nail gap, let it dry, sand it, and do it once more. After you have it crammed and sanded dry, paint it.

The screws will maintain up very effectively, and you’ll hopefully by no means have to do that course of once more!

Watch: Tips on how to Substitute a Drywall Nail


Tips on how to Increase an Out of doors Dryer Vent

This image is of an outdoor dryer vent.
An out of doors dryer vent ought to be no less than 12 inches from the bottom. (3 Echoes Content Studio)

A home-owner’s dryer vent runs on an exterior wall and underneath the brick veneer. It’s put in about an inch off the bottom as an alternative of 12 or extra (the advice).

He has bother with stormwater stepping into the vent, and now asks, “Do you’ve any suggestions for me?”

First, it’s uncommon to discover a dryer vent so low to the bottom. It’s potential that when the vent was initially put in, it was the right peak off the bottom. Nevertheless, as time handed, grading and landscaping might have been added, and the vent acquired nearer to the bottom.

To make this dryer vent work effectively, you’ll wish to have as wanting a path as potential. So, we don’t suggest rerouting the present ductwork and going by the soffit.

As an alternative, we suggest attempting to raise or prolong the prevailing vent upward, or digging dust across the vent to provide it more room. You may additionally add a slight flip and elbow to get it off the bottom.

Examine your native house middle for a tool that curls up at 90 levels, which can assist elevate the vent on the surface. There are numerous dryer vent choices.

For security, don’t use PVC pipe for an elbow as a result of it can not deal with the excessive temperatures that come by a dryer vent.

As well as, ensure you continuously clear your dryer vent to stop home fires and maintain your dryer working effectively.


Hour 2

Take heed to study rubbish disposal guidelines, how you can repair a bathroom that received’t flush, how you can lay an underlayment over a tile ground, and extra!


What You Can Put Down a Rubbish Disposal

This image is a below the sink image of a garbage disposal.
It’s acceptable to place issues down a rubbish disposal if they’re sufficiently small. (3 Echoes Content Studio)

A home-owner and his spouse have had an ongoing disagreement about whether or not it’s okay to place scraps of meat down the rubbish disposal. They’ve septic tank disposal.

He says, “Can you compromise this debate?”

It’s completely fantastic to have a rubbish disposal with a septic tank. Nevertheless, some septic tanks are actually good, and others are very marginal. That performs a big half within the disposal’s performance and what waste it accepts.

So, what could be put down a rubbish disposal?

With regards to rubbish disposals, you do wish to use them sparingly and never put every part down it. You wish to keep away from placing giant substances down.

The reply to the query could be sure, however solely small items of meat, and don’t pack it full.

Ensure you use and preserve rubbish disposals accurately. It is suggested to make use of chilly water to clean waste down the drain and make sure you don’t put one thing within the rubbish disposal and never run it!

In case your rubbish disposal will get clogged, use this trick!


Tips on how to Clear up Rest room Flushing Points

This image shows the inside of a toilet, specifically focusing on the chain and flapper.
Adjusting the chain is a simple repair to unravel bathroom flushing points. (3 Echoes Content Studio)

A home-owner is struggling to get her bathroom to flush fully. She says she has to carry the deal with down till the bowl is flushed.

She desires to know, “Why does this occur, and the way can I repair it?”

There are two causes that she could also be having this downside. One, there’s not sufficient water within the tank, which means the water stops earlier than reaching about half an inch under the overflow tube. That’s the place you wish to regulate it.

Subsequent, you wish to make sure that whenever you push down the deal with, the flapper stays open to permit the flushing motion after which closes. If the chain is just too brief or too lengthy, that may forestall that from occurring.

Another excuse is an obstruction within the drain. If there’s an obstruction, then you definitely received’t get that flushing motion as a result of it’s resisting the water going into it.

It’s most definitely the primary downside. This can be a quite common repair, and there are many nice repair kits on the market. Do that shortly so that you received’t waste water!

Though fixing a bathroom won’t be probably the most glamorous type of house enchancment, it’s so essential to have a working bathroom that may keep in fine condition for a very long time.

Additional Studying: Information to All of the Components of a Rest room Tank


Tips on how to Set up an Underlayment

This image shows a notch trowel applying a grout to a wood floor.
Ensure you use the proper notch trowel measurement to put in an underlayment. (3 Echoes Content Studio)

A home-owner desires to place a quarter-inch underlayment over a tile ground.

He asks, “Do I have to nail or screw it? What do I take advantage of?”

No, you aren’t going to wish to nail by or screw it. You’ll have to glue it down. Perform some research and discover the proper adhesive you want, relying on the supplies you’re utilizing. Most certainly, it is going to be in a bucket, and also you’ll use a notch trowel to put in the correct quantity.

Just be sure you learn the instructions to make sure you use the really useful notch trowel measurement. Lots of people don’t notice that the dimensions of the notch trowel must correlate with the adhesive in an effort to work effectively.

To make sure there isn’t a motion when placing down the ground, use leftover blocks, bricks, or heavy objects to weigh it down a little bit bit. Go away it in a single day so that it’s going to dry and actually remedy effectively.

There are a number of choices for underlayment. One possibility is a self-leveling underlayment. That is like actually skinny concrete. Do a skinny coat over the tile to create a easy and flat floor for a vinyl ground to be put over.

Additional Studying: Gluing vs. Nailing Hardwood Flooring


Finest New Merchandise

The StyleWell Parker Mill 4-Piece Steel Patio Set is sturdy and long-lasting, offering you with the outside furnishings you’ll be able to depend on. Study extra>>

Easy Options

This image shows a push broom cleaning a tile floor.
Use a push broom earlier than portray to take away mud and dust from partitions. (®JodiJacobson by way of Canva)

Push Broom Paint Prep—Previous to portray a room, it’s essential to scrub the partitions and ceiling to take away all mud, dust, and cobwebs. Right here’s a fast and straightforward method to do this: Wrap a towel across the head of a push broom, and safe it with a binder clip or pinch clamp. Then frivolously mist the towel with water. Now use the towel-wrapped broom to wipe down the partitions and ceiling. The damp towel will entice any mud or dust, abandoning a clear, ready-to-paint floor. This tip additionally works nice to take away joint-compound mud from newly sanded drywall joints.

This image shows a person gluing concrete blocks together.
Use concrete blocks to create straightforward storage to your gardening instruments. (3 Echoes Content Studio)

Straightforward-Entry Backyard-Software Storage—Most individuals retailer their garden and backyard instruments within the storage or shed by merely standing them up and leaning them within the nook. There’s nothing notably incorrect with this besides that it’s a little bit messy, and it’s laborious to seize one instrument with out knocking over one other. So, right here’s a brilliant easy resolution to that downside: Take three concrete blocks and stack them up wherever you wish to retailer your instruments. What you find yourself with is 2 deep compartments for storing long-handled instruments. The blocks are heavy sufficient that you simply don’t have to fret about them falling over, irrespective of what number of instruments you set in there. If you happen to don’t have sufficient headroom, you should utilize two blocks so you’ll be able to elevate the instruments out. This gives you a neat place the place your instruments are out of the best way and simply accessible, and also you don’t have to fret about them falling over.


Additional Studying